First of all, drywall is basically a popular term for prefabricated plaster wall panels. These panels are usually very easy to install but you need to remember that you have to do it properly in order for you to avoid encountering problems that can lead to costly and time consuming repair.
This is why you have to know how to avoid the common mistakes that is usually associated in installing drywalls. This will help in saving yourself the headache of redoing the entire job all over again, which can be very costly and can really lead you to have a very big headache.
So, here are some tips that will enable you to avoid the common mistakes in installing drywall and save a lot of time and money on repairs.
The first tip will concern the surface on which you will install the drywall on. The walls should be flat and the framing should be straight at right angles. You also have to remember that the studs or rafters that are bowed should be planed first in order to flatten them before you work on them.
To test if the wall is flat and straight, get a piece of string and stretch it across the walls in order to make sure that the studs are all on the same plane. If it is not, plane it again and check again.
When cutting the prefabricated plaster wall panels or drywalls, you will find that it is very simple to do as it doesnt involve any sawing in order to separate it. You also dont need to cut all the way through the drywall. Doing so will only result to a prematurely-dull utility knife and a scratched surface underneath.
The proper way to cut drywalls is by drawing a line across the panel. Make sure that the line you draw is completely straight. This can be achieved by using a drywall T-square. Then, you have to score down this line just deep enough to cut through the backing paper. After doing this, all you need to do is lift the panel and snap it right down the line or the guide. To complete the cut, you can then slice through the remaining layer of backing paper and you have to smoothen any rough edges.
You also have to keep in mind that it is very common for people to go overboard when they apply the joint compound or the mud when it comes to taping or mudding the drywall. Always keep in mind that you should never work the joint too much and at a very early stage.
A great way to do this is by first applying the tape and spread a thin layer of compound over the tape to embed it. Then, you have to leave it to dry before you scrape it slightly to level any high spots. You can apply a second layer if it is necessary or if the first layer isnt enough.
These are the proper ways on how you can properly install drywalls on your home. By following these tips, you can be sure that you will be able to avoid costly mistakes in drywall repair.